SendActivationCode
Sends an activation email to the email address associated with the specified email contact.
Note
It might take a few minutes for the activation email to arrive. If it doesn't arrive, check in your spam folder or try sending another activation email.
Request Syntax
POST /2022-10-31/emailcontacts/arn/activate/send HTTP/1.1
URI Request Parameters
The request uses the following URI parameters.
- arn
-
The Amazon Resource Name (ARN) of the resource.
Pattern:
arn:aws:notifications-contacts::[0-9]{12}:emailcontact/[a-z0-9]{27}Required: Yes
Request Body
The request does not have a request body.
Response Syntax
HTTP/1.1 200
Response Elements
If the action is successful, the service sends back an HTTP 200 response with an empty HTTP body.
Errors
For information about the errors that are common to all actions, see Common Errors.
- AccessDeniedException
-
You do not have sufficient access to perform this action.
HTTP Status Code: 403
- ConflictException
-
Updating or deleting a resource can cause an inconsistent state.
- resourceId
-
The resource ID that prompted the conflict error.
- resourceType
-
The resource type that prompted the conflict error.
HTTP Status Code: 409
- InternalServerException
-
Unexpected error during processing of request.
HTTP Status Code: 500
- ResourceNotFoundException
-
Your request references a resource which does not exist.
- resourceId
-
The ID of the resource that wasn't found.
- resourceType
-
The type of resource that wasn't found.
HTTP Status Code: 404
- ThrottlingException
-
The request was denied due to request throttling.
- quotaCode
-
Identifies the quota that is being throttled.
- retryAfterSeconds
-
The number of seconds a client should wait before retrying the request.
- serviceCode
-
Identifies the service being throttled.
HTTP Status Code: 429
- ValidationException
-
The input fails to satisfy the constraints specified by an AWS service.
- fieldList
-
The list of input fields that are invalid.
- reason
-
The reason why your input is considered invalid.
HTTP Status Code: 400
See Also
For more information about using this API in one of the language-specific AWS SDKs, see the following:
