Use wscat to connect to a WebSocket API and send messages to it - Amazon API Gateway

Use wscat to connect to a WebSocket API and send messages to it

The wscat utility is a convenient tool for testing a WebSocket API that you have created and deployed in API Gateway. You can install and use wscat as follows:

  1. Download wscat from https://www.npmjs.com/package/wscat.

  2. Install wscat by running the following command:

    npm install -g wscat

  3. To connect to your API, run the wscat command as shown in the following example. Note that this example assumes that the Authorization setting is NONE.

    wscat -c wss://aabbccddee.execute-api.us-east-1.amazonaws.com/test/

    You need to replace aabbccddee with the actual API ID, which is displayed in the API Gateway console or returned by the AWS CLI create-api command.

    In addition, if your API is in a Region other than us-east-1, you need to substitute the correct Region.

  4. To test your API, enter a message such as the following while connected:

    {"{jsonpath-expression}":"{route-key}"}

    where {jsonpath-expression} is a JSONPath expression and {route-key} is a route key for the API. For example:

    {"action":"action1"}
{"message":"test response body"}

    For more information about JSONPath, see JSONPath or JSONPath for Java.

  5. To disconnect from your API, enter ctrl-C.