This is version 2.20 of the AWS Elemental Statmux documentation. This is the latest version. For prior versions, see the *Previous Versions* section of [AWS Elemental Statmux and AWS Elemental Live Documentation](https://docs.aws.amazon.com/elemental-live).

# Add Ethernet Devices
<a name="config-wrkr-sm-cg-ethernet-add"></a>

When you installed AWS Elemental Statmux, you configured eth0. If you also set up eth1 at that time, no further configuration is required. If you didn't set up eth1 or want to set up more devices, use these instructions to do so.

**To add Ethernet devices**

1. On the AWS Elemental Statmux web interface, go to the **Settings** page and choose **Network**.

1. On the **Network** page, choose **Network Devices**.

1. On the **Network Devices** page, choose **Add Network Device**.

1. In the **Add a New Network Device** dialog, select **eth (ethN)**.

1. Complete the fields as follows:
   + **Device Name**: Select the eth device that you're setting up.
   + **Address Mode**: Select the type of IP addresses this device uses, either **dhcp**, **static**, or **none**. If you're bonding eth0 and eth1, use static IPs. 
   + **IP Address**, **Netmask**, **Gateway**: Available when static IP addresses are used only. Complete with your networking information.
   + **Static Routes**: Select if you're using static routing.
   + **Network**, **Netmask**, **Gateway**: Available when static routes are used only. Complete with your networking information.

1. Choose **Save**. The new device appears in the Network Devices list.