# Setting up a SMPTE 2110 input using NMOS
<a name="setup-2110-input-nmos"></a>

Follow this procedure if you have a SMPTE 2110 source and your organization uses NMOS IS-04 and IS-05.

**Note**  
This section assumes that you have read [Working with SMPTE 2110](SMPTE-ST-2110.md) and are familiar with how SMPTE 2110 works and with its prerequisites.

You must enable NMOS on the appliance, as a one-time action. Then the setup of a SMPTE 2110 source is a two-step process. First, you create a 2110 receiver group to replicate the SMPTE 2110 receivers in Elemental Live. Then in the event, you create an input that uses the 2110 receiver group. In this way, a SMPTE 2110 source is similar to an SDI source, which is represented in Elemental Live by an SDI device that is used by an SDI input.

**Topics**
+ [Enable NMOS](s2110-nmos-configure.md)
+ [Obtain information from the NMOS operator](s2110-nmos-obtain-info.md)
+ [Determine the SDPs to create](s2110-nmos-design-sdps.md)
+ [Create the receiver group](s2110-nmos-create-receiver-group.md)
+ [Create a receiver group input](s2110-nmos-create-input.md)
+ [Choose the resiliency scenario](s2110-nmos-scenarios.md)
+ [Resiliency scenario A: Supporting NMOS patching](s2110-nmos-scenario-patching.md)
+ [Resiliency scenario B: Supporting NMOS patching and failover](s2110-nmos-scenario-patching-plus-failover.md)
+ [Resiliency scenario C: Supporting NMOS patching and network failover](s2110-nmos-scenario-patching-nw-failover.md)